Installation Guide

Housinghouse HID kit / Mar-17-08

Separate the headlamps(right & left)from your car after opening your car bonnet. if there is enough space for exchange, it is not needed to separate the headlamps from your car.

Open the rear cover of the headlamp and pull the installed halogen lamp out.

 Drill a hole in the middle lf the rear cover of the headlamp with a 21mm hole cutter.

 Take out the plastic cap of the HID bulb.(be careful not to touch the bulb.)

 Put the HID lamp into the headlamp unit. ( caution: please confirm whether the installation of press spring has settled properly after installing the lamps. )
Caution: please check again whether the installation is proper after installing the lamps.

 Connecting the wires-referring to the wiring diagram in the guide book. 

Close the cap of the headlamp after fitting the rubber barking attached to the bulb’s wire into9 the unit’s cover.

 Stick the ballast on the nearest place from the headlamp in the engine room firmly by using double-faced tape , cable tie and etc. 

Connect the wire of the ballast with the wire of bulb. 

Test whether or not the headlamps work properly. 

*If both lamps don’t light at the same time or flicker ,change the battery to more than 60Ah since it results from the lack of electric power; or add relays to bear more than 15A since it results from the lack of electric current.  

*Make sure to change the fuse for the headlight to at least more than 20A. If you use the fuse less than 20A,it tends to be out when the light turns on.

Prev：HID purpose photos Next：H4 Hi/Lo Installation Instructions